Board index Onkyo Europe Home Theater Systems TX-NR656 glitches in HDMI video after starting the unit

TX-NR656 glitches in HDMI video after starting the unit



Posts: 1
I recently purchased TR-NR656, but I'm experience an annoying issue.

My amplifier is connected to a video projector using HDMI, and also my video sources are connected to the amp with HDMI. When I turn the power on in the amp, every few seconds there is a glitch in picture. The glitch looks like static noise and lasts for one frame, but is very annoying. After a few minutes the glitches are gone (the amp has warmed up?).

I was able to video some glitches and included screenshot of one.

I have tested with two HDMI inputs and two cables, and experienced the same problem. The cable from HDMI output to video projector works without problems when connected directly to a video source, and I never experienced the issue with my previous amp, so I'm pretty sure Onkyo is to blame.

Is this a known issue? Any ideas what I could try?
Attachments
glitch.jpg
Glitch
glitch.jpg (77.13 KiB) Viewed 153 times


Posts: 1
The link from HDMI yield to video projector works without issues when associated specifically to a video source, and I never encountered the issue with my past amp, so I'm almost certain Onkyo is to be faulted. Buy Dissertation


Return to Home Theater Systems

cron